Project setup

DEMO DATA

Define the scope, locations, standards and guidance sources for this audit cycle. These details populate every dashboard and generated output.

Project details
Pre-populated with sample values — edit freely.
System metadata
Read-only — assigned by Lazomis QI.
Tool type
Audit Tool
Project type
Clinical Audit
CQC domains
Safe
Effective
Caring
Responsive
Well-led
Patient Flow project
Yes
Patient Flow categories
Admission
Emergency Department
Acute Medical Unit
Specialty inpatient care
Ward care
Discharge planning
Community services
Clinical themes
Pressure Ulcer Prevention
Tissue Viability
Documentation
Frailty
Nutrition and Hydration
Patient Safety
Aligned standards
NICE CG179
NICE QS89
Website categories
Acute Medicine
General Medicine
Nursing
Patient Safety
Clinical Governance
Clinical safety note
This tool supports local audit, quality improvement and governance review. It does not replace clinical judgement, nursing assessment, tissue viability advice, local pressure ulcer prevention policy, safeguarding processes, incident reporting, wound assessment, medical device safety checks, nutritional assessment or emergency escalation pathways. Any new pressure damage, suspected deep tissue injury, deteriorating wound, pain, infection concern, safeguarding concern, unsafe equipment delay or serious patient safety concern must be escalated according to local policy. Do not enter patient names, NHS numbers, hospital numbers, full dates of birth, addresses or other direct identifiers.
Locations, departments and specialties in scope
Project-level selections used in the data collection form, dashboard filters and exports. Multiple areas can be audited in one project.
Wards / units
Ward, unit, clinic, community team or care home.
Departments
Specialties
Services / pathways
Guidance, standards and sources
National guidance and local policies this audit is measured against. Sources marked for display appear in Resources; sources marked for exports are listed in generated outputs.
Custom fields
Add project-specific fields to capture local variables. These appear in Data collection, Submissions and relevant exports.